Tractor Talk Discussion Board |
Re: Farmall H engine seized
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by danimal2 on June 05, 2006 at 16:59:06 from (63.98.154.242):
In Reply to: Re: Farmall H engine seized posted by glennster on June 05, 2006 at 11:30:32:
Thank you for your reply. Yours seems to be along the lines that I am starting to think. I pulled the oil pan and the valve cover and everything looks to good. I do not have any history on this tractor. It is set up for LPG and does not look as if it is all hooked up right as far as the LPG is concerned. The tractor does roll in Neutral. I do have the inspection plate for the clutch off, but have not taken a flashlight to inspect it as of yet. I will do that on Wed. or Thurs., my day off. Can one replace bearings without pulling the whole thing apart. Thank you again for your informative reply, Daniel
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|