Tractor Talk Discussion Board |
Re: FORD 841 POWERMASTER IMPLEMENTS SIZE
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JWCinMS on June 06, 2006 at 11:02:28 from (199.133.80.226):
In Reply to: FORD 841 POWERMASTER IMPLEMENTS SIZE posted by SKFOOTER on June 06, 2006 at 10:31:13:
A safe choice for mixed cutting (mostly grass and weeds with occasional brush and briars)would be a medium weight 5' cutter with a slip clutch. A medium or heavy duty 6' cutter would be a lot of weight on the rear of the tractor and could cause stabiltiy issues. These tractors were most often sold new with 20 or 24 pan disk harrows. The 20 pan Ford disk harrows were about 6-1/2 feet wide. Using a 24 pan disk would probably require ballast in the tires when disking plowed land. The 24 pan disk would also be a little wide for a 6-1/2 foot wide pipe or angle top trailer.
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|