Tractor Talk Discussion Board |
Re: I want to float my tractor, but...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RND on June 07, 2006 at 16:09:19 from (72.226.26.17):
In Reply to: I want to float my tractor, but... posted by Jason, NW Ontario on June 07, 2006 at 05:50:37:
I have a 18 ft 7000 lb trailer with (2) 3500 lb axles. I haul a JD 4410 with loader & backhoe. Rears are loaded. Tractor weighs ~ 5000 lb, so close to trailer capacity (Trailer weighs 1750 lb). I bent the rear axle of the trailer while loading & unloading the tractor. The load on the rear axle is highest while loading. You should consider adding jacks on the back of the trailer to protect the rear axle if you are loading the trailer near it's load limit.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|