Tractor Talk Discussion Board |
Re: In the doghouse - broke brush hog blade
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fritz Campbell on June 17, 2006 at 19:57:06 from (204.11.80.100):
In Reply to: In the doghouse - broke brush hog blade posted by Fritz Campbell on June 17, 2006 at 14:51:40:
Here is my plan. I'll go over to TSC tomorrow and see if I can match the blade. I'll buy two of the closest match and replace both at the same time. If I can't find a match, I'll order them. If ordering takes forever - I'll remove both blades, weld the broken blade and grind either or until they weigh the same. I've talked to some guys that have welded blades with mixed results - most say they have had few problems - but they are pretty careful where they are mowing and don't cut much heavy brush OR STUMPS. I could kick myself too because I had my chainsaw right there and told myself I'd better ground cut it low because it was too high to mow over, but I didn't want to take a chance of grounding my fresh chain so I didn't cut it. Now I wish I would have. Resharpening a chain is alot quicker than replacing brush hog blades. Anyway, I'll post back with my experience. Thanks to all.
Replies:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|