Tractor Talk Discussion Board |
Re: Got very very lucky today
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Cliff Neubauer on July 06, 2006 at 19:10:47 from (69.18.16.224):
In Reply to: Got very very lucky today posted by old on July 06, 2006 at 16:45:00:
We used to have a 15' no-till drill that had alot of negative tongue weight and I managed to loose the pin out of it twice over the years. With the negative tongue weight the hitch would rock up and down and work the pin out the top. I finally learned to loop a piece of #9 wire from the hitch pin handle down through the pin's hole and back up to the handle where I tied it good. It was a pain to get the wire back out through the pin but but smaller wire or the hair pin clips would get pulled out by corn stalks when drilling beans.
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|