Tractor Talk Discussion Board |
Re: Hayracks revisited Picture
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MN Bob on July 11, 2006 at 07:16:42 from (24.179.180.82):
In Reply to: Hayracks revisited Picture posted by IaGary on July 11, 2006 at 07:00:17:
Hi Gary; Happen to have a picture of how he attached the back board frame? Welded or bolted? He obviously did a good job. Is that channel iron 1/4 inch? And a question for any one, If I extend the center pole to accomidate a longer wagon (its adjustable) from the present 14 feet to 16 or 18, do I need to re-enforce the pole in any way? What would be the minimum? This one is two square tubes with a smaller square as the extension. Not sure of the size right now but probably 4 inch on the large tube. Needs a new floor now. Bob
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|