Tractor Talk Discussion Board |
Re: pontiac transam
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hal/WA on July 11, 2006 at 18:14:18 from (66.45.175.118):
In Reply to: pontiac transam posted by marlowe on July 11, 2006 at 17:42:35:
You didn't mention what year and engine you are dealing with. If it is a TPI engine, I don't think that there should be gas at the throttle body, since each port has its own injector. Maybe they made TransAms with TBI, like on a truck engine, but I have never seen one or read about a T/A having one. I would check to see if the computer has trouble codes stored. Depending on the year, you may need to use a scan tool to do this. While a trouble code will not tell you exactly what is wrong, it should send you in the right direction. Often it is a bad component or sensor, or a bad connection. On the computer controlled engines, sometimes the computer shuts off the electricity to the fuel pump if you crank it over longer than the programming allows without the engine starting. I would make sure all electrical connections and wiring appear to be good. If the computer is not getting the signals it needs to make it run right, the computer might very well shut things down. I had an old Plymouth with computer controlled TBI that intermittantly would just shut down. Usually letting it cool down for awhile or removing the battery cable would let it start again, and then it might run fine for a week or so. I tinkered with it for months and could not find anything wrong, nor were there any trouble codes showing. Finally, I changed the whole distributor and in so changed the pickup coil, and it never stopped again. It must have been the pickup coil, although that always tested as working properly. The electronic fuel injection engines are complex systems, but usually they can be fixed. You might want to read up on how your system works before you tear into it very much Good luck!
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|