Tractor Talk Discussion Board |
Re: Wire corn cribs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by FreeRanger on July 12, 2006 at 06:57:50 from (130.47.34.2):
In Reply to: Wire corn cribs posted by Richard G. on July 12, 2006 at 06:18:55:
I purchased one at an auction for $90 in like new condition. Took my father, brother and me about 4 hours to disassemble with an air compressor and scafolding. Look for this style. Mine is like hog panel set on end and bolted together at the seams. Each panel is 4 foot wide by 16 feet long. Making the crib 16 feet tall, plus the sheet metal roof (about another 8 feet tall). This one is 16 feet in diameter to make 1500bushel? the bolts came about easily and we cut the bottom brakets off at the concrete floor. the whole thing fits on a trailer for shipping across the country. I haven't put it back together yet because I can't afford the concrete floor. I am afraid a dirt floor won't anchor it down in a wind storm. I plan to put red golden pheasants inside mine. Might cut it in half to make two 8 foot tall enclosures. One with a metal roof the the other with netting across the top.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|