|
Tractor Talk Discussion Board |
Re: OT: classic truck brakes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by nballen on July 24, 2006 at 14:34:27 from (198.246.171.252):
In Reply to: Re: OT: classic truck brakes posted by RustyFarmall on July 24, 2006 at 13:43:11:
Hi Rusty, I do hear you on the failed brakes - its downright scary! About 4 years ago, I blew a wheel cylinder on my '63 dodge. I was pulling a trailer (with brakes) at the time, so that helped...just not enough! I hope you didn't misunderstand me - I'm not trying to skimp on this project - which I why I am tearing into the booster, not just rebuilding the wheel cylinders and master cylinder. On the other hand, I don't have a very big bank to try and break, either! Could you be specific on why I should "get a professionally rebuilt unit"? Is rebuilding booster significantly different from rebuilding a master cylinder or wheel cylinders? Is there a warranty on rebuilt units, or is the operator still on the hook for any damages? (It seems like it would be difficult to prove faulty components or workmanship in a rebuilt unit.) I want to do a good job with this project - to have a usable truck that is safe and enjoyable to operate. Anyhow, seems like whether I want to be or not, I am responsible for the safe operation of any equipment I am using (whether owned, borrowed, or rented)! Best Regards, Nathaniel
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
