|
Tractor Talk Discussion Board |
Re: Need help with an Explorer Fuel Filter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Vern-MI on July 25, 2006 at 11:03:38 from (207.69.137.12):
In Reply to: Need help with an Explorer Fuel Filter posted by Bill46 on July 25, 2006 at 10:29:00:
I have a 2000 Explorer and the filter is located in the frame right under the drivers feet. It was a bear to get the clips to release. It uses a dual clip design where a second safety clip is installed parallel to the garter clip. It requires a special tool to release the clip so if you did it yourself you probably would have spent in the neighborhood of $40 for filter and tool. The filter itself was $20 at a parts store so I imagine it was more at the dealer. I guess that $58 is about average for the job. I stopped at the dealer and thought I would buy a new oil drain plug for this car. They wanted $14.85 for just the plug. Wow! I ended up down the street at Autozone and got it for $5.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
