Tractor Talk Discussion Board |
White 2-70 hydraulic pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill in NorthCentral PA on July 27, 2006 at 12:26:53 from (24.229.41.251):
This gear drive hydraulic pump needs a couple of seals / gaskets (rubber and some kind of fiberglass). The original pump was replaced with one from the AGCO dealer several years ago and when asked for gaskets, they supplied a different size. The couldn't guarantee the gasket kit to fit the pump they had on the shelf. The pump itself doesn't have a name stamped on it, but does have "DP" marked as well as H77X3142 and 656876 and L070802. The local shops don't have any idea where to go with this and I hate to put a $600 pump in when seals are all that are needed. It seems so simple, I'm just not "In the know" like some of you are. Any advice? Thanks in advance, Bill
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|