Tractor Talk Discussion Board |
Farmall Super M LP acts like it is flooded
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Larry Williams on July 31, 2006 at 20:05:32 from (65.143.98.187):
My 53 Farmall super M LP was running great. I use it to power an irrigation pump. It had just completed running for about 6 hours the night before. I went to get it and take it to the fuel tank. It started fine but when I let the clutch out it acted like the choke was pulled all the way out. It is an LP and it don't have a choke. It would run fine until it encountered ANY small load then it started having trouble. I nursed it to the shop and it got worse along the way. I have been through the regulator and found nothing wrong. Took the bottom half of the carb. off and cleaned. Nothing wrong. Fuel is coming to the carb. I can take the hose off the bottom of the carb and fuel will come out of the hose when I press the button on the side of the regulator but it will not flow all of the time. I am under the impression the carb should draw the fuel, not be force fed, and this appears to be the case. It is NOT being force fed. I have cleaned the air cleaner and am confidant it is getting air freely. I have even removed the hose from the carb to the air cleaner just to be sure. The more I mess with it the worse it gets. I have put new points, condenser, plugs, wires, rotor, cap and set the timing. Now it will just barely start and run for maybe 4 or 5 seconds and then die. I was starting to restore it little at a time so I have a new battery, both cables are new, new wires from the coil to the switch, and several other things not related to engine performance. I am at a loss at this point. What else is there? I need this thing to get to work and pump water quick. Please help. I am open to ANY suggestion. Thanks.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|