Tractor Talk Discussion Board |
Re: OT: leach bed vs. mound system
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the Unforgiven on August 02, 2006 at 21:52:12 from (199.184.119.22):
In Reply to: OT: leach bed vs. mound system posted by Farmer boyy on August 02, 2006 at 18:35:00:
Sitting idle should not bother a bit. When I install a new drainfield I put it in a couple inches below the old one but keep the old one hooked up, it will dry up and give more service when the new one is getting tired. If you do put in a tank it must be full of water up to it's operating level, they really suck when they float out of the ground. And stay away from the 4 inch perforated pipe. If your add up the surface area of all those little holes you don't have squat. A product called Infiltrator is tough to beat, it is an "A" frame plastic tunnel that is easy to install and offers massive surface area on the sides and bottom, one eight foot piece will outperform a hundred feet of perforated pipe. I usually put in 50 to 80 ft of it, here in NE anyway.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|