|
Tractor Talk Discussion Board |
two cylinder with cabs questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Adam Koch on August 06, 2006 at 15:40:07 from (70.225.90.108):
I just purchased a 830 with cab out of montana, it's coming to illinois this week. I have seen them in pictures but never in person. evidentelly up north and out west they are common, but here in Illinois they are far and few between.When it was new, did the tractor go right from the factory to another place to have a cab installed? Did john deere even make a cab For the old Two Cylinders? Can it be taken off very easily? Is there any way to know if it's been on the tractor since it was new? How many were made?
If any one has any information it would be greatly apreciated, possiblly a web site? Or you can even call my cell. Thanks in advance
Adam Koch Aviston Illinois
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
