Tractor Talk Discussion Board |
Re: B FARMALL WIRING
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on August 07, 2006 at 14:46:22 from (66.244.90.5):
In Reply to: B FARMALL WIRING posted by ANDREW of SNOW HILL N.C. on August 07, 2006 at 14:23:01:
Andrew, When using a 4 pole VR with the (L)oad terminal, the L terminal is what feeds hot battery voltage to all the loads such as lights and igition via the BAT input terminal on those switches. On a 3 pole VR that doesnt have the extra 4th L terminal, those loads are fed voltage from the ammeters Load terminal, being the same ammeter terminal that wires down to the BAT terminal on the VR. Sooooooo the ammeters load terminal wires to the BAT terminal on that VR and then a wire from its L terminal is what feeds input voltage to lights and ignition switch(es). Its possible to make a 3 pole VR work in place of a 4 or vice versa, its just a matter of where loads like lights n ignition receive their voltage from, the load side of the ammeter on a 3 pole VR system but the L terminal on the 4 pole VR system. To answer your question, the L terminal wires up to the dash to power up the switches (lights and/or ignition) on their BAT input terminals. John T
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|