Tractor Talk Discussion Board |
Re: antifreeze changing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by burnetma on August 18, 2006 at 18:51:07 from (24.39.218.58):
In Reply to: antifreeze changing posted by trouble on August 18, 2006 at 17:11:21:
Trouble, First of all, thoroughly look over the cooling system. Check the condition of all hoses and check for leaks around the radiator, water pump, head gasket, thermostat, water necks, etc... Then remove the radiator cap and look down inside. There should be little or no white deposits on the tube ends. If everything in the cooling system passes the eyeball check move to step 2 which is the chemical condition of the antifreeze. The chemical condition of the antifreeze can be checked using test strips that can be purchased at NAPA and other automobile stores (be sure they know that you are testing green antifreeze). The strips are simple to use. Using a set of clean needle nose pliers, dunk the strip in the filler neck for the specified time. Allow the strip to develop, as per the instruction, and check the color vs. the code on the instructions. The test strips test for three conditions of the antifreeze; PH, Nitrites and freeze point. If PH or freeze point are out of range, change the antifreeze as soon as possible. If nitrites are out of range low, you could (underline) add a conditioner to the system to increase the nitrite count (more important on diesels than gas engines). Typically nitrites are out of range high with most multipurpose antifreeze (i.e. standard yellow bottle Prestone or knock-off brands) and this is OK for gas engines. Diesel engines should use specially formulated antifreeze. I hope this was helpful. Mark PS Note that SCA"s are REAL important on wet sleeve diesels. Not so much an issue on gas or dry sleeve diesel engines.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|