Tractor Talk Discussion Board |
Re: cutting speed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CharleyFarmall on August 21, 2006 at 20:00:16 from (208.11.23.13):
In Reply to: cutting speed posted by raleigh on August 21, 2006 at 18:15:50:
Well, I am doing Exactly what you are asking to do. It"s taking forever and a lot of fuel to boot. I have done a bit over 30 acres so far and have almost 20 more to do, plus, I need to do a second pass on 16 of them. Get a bigger hog. I"m looking for one that"s affordable but think I am going to get an 88" flail mower. I have not been able to go faster than 4.5mph either and have so far done about 14 hours worth. Hopefully I won"t ever have to bushog Everything again...
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|