Tractor Talk Discussion Board |
Re: jubilee
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by john in la on August 31, 2006 at 23:03:34 from (68.222.52.44):
In Reply to: Re: jubilee posted by dp4kids on August 31, 2006 at 15:41:56:
Like I said before; I do not own a 4 speed trans so I can only go by what the manual says about it. If you go back to the main page of this site and scroll down you will see a section titled FORD. Go down there and ask your question as others do know a lot more about the 4 speed than I do. I will put a link to the Ford board if you have problems finding it. Now with that said you should be able to remove the top (in netural) and work the shifting forks by hand and see the couplings moving applying the gears. Make sure all are in the netural (center position) position and then install the top.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|