Tractor Talk Discussion Board |
Re: And It Gets Better
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on September 03, 2006 at 08:49:57 from (75.24.23.92):
In Reply to: And It Gets Better posted by Allan In NE on September 03, 2006 at 08:29:34:
Well Allen all ya will be out is a Gskt. and O/Ring if ya got to pull her back down and some time . Now it would be nice to have it Flow rated and see if it is doing what it is suppose to . Now from what i am told here is that if ya are using the 17 GPM pump then you should have the aftermakket dual filter adapeter that one company offered and i am tryen to think if that was BMD or aillied been a few years ago since there travelen salesman was tryen to get me to switch from Hy Cap to them as both tryed to get my businessbut they did not offer any warranty as to payen for my labor in the event that one of there products failed where Hy Cap did but never had to use it as never had a failure . Now i could see the advantages to the Stacked filters and allowen more oil to flow thru a larger area as from what this guy was tryen to sell me that the filter was only good for 15 GPM but i was having a hard time swallonen his sales pitch since that you could order them with the 17 GPM pump from the factory .. Atleast put a gauge on her and see if it will come up to pressure at and ideal .
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|