|
Tractor Talk Discussion Board |
Re: And It Gets Better
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on September 03, 2006 at 08:55:42 from (148.78.243.26):
In Reply to: Re: And It Gets Better posted by BobHnwOh on September 03, 2006 at 08:45:25:
I'm really fightin' with myself on this one; I just don't wanna do this job again. But, when I bought this tractor, the locals told me that there is no way that the loader could have more than 50 hours on it 'cause right after they sold it to him, the tractor went down and he just parked the old thing. I'm throughly convinced that the pump was new with that loader because the loader was plumbed to work off the tractor hydraulics and it had one of those fancy electric over hydraulic controls installed also. On the other side of the coin, there was a problem going on with that hydraulic system the day I bought it. Look at that hitch....... Would you go to the trouble of replacing the pump while you were in there, if you were I? Allan 
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
