Tractor Talk Discussion Board |
Re: Compression ratio converted to PSI
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Maybe,,, on September 06, 2006 at 16:33:36 from (66.228.96.177):
In Reply to: Compression ratio converted to PSI posted by Brad in WI on September 06, 2006 at 02:14:17:
Just a guess,,,,, 100 psi 5 to 1 120 psi 6 to 1 140 psi 7 to 1 160 psi 8 to 1 180 psi 9 to 1 200 psi 10 to 1 220 psi 11 to 1 240 psi 12 to 1 260 psi 13 to 1 280 psi 14 to 1 300 psi 15 to 1 Thats just a guestimated pressure to compression ratio at cranking speed. There is no real way to make it exact, unelss you spec the engine out at 14.2 to 1 etc etc then run a compression test to get a relative psi number at cranking speed.
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|