|
Tractor Talk Discussion Board |
Re: OT Freightliner fl70
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jimmy King on September 16, 2006 at 02:10:51 from (207.69.137.23):
In Reply to: OT Freightliner fl70 posted by 901powermaster on September 15, 2006 at 14:57:06:
Where I work we drive FL 70 Freightliners. When I went to work in 1997 we had one Ford, one FL 60, and One FL 70 all with the 5.9 and 5 speeds we had no trouble except with the Ford and it had to be OH ed. The next trucks had the C cummins with 6 speeds, we had a lot of trouble with them. Now we have Cats, and we have had a lot if trouble with the older ones the two new ones haven't caused any. These are Ryder Leased Trucks and we put 400,000 on them.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
