Tractor Talk Discussion Board |
Re: tractor pulling hitches
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by colekicker on September 19, 2006 at 19:50:03 from (24.249.157.6):
In Reply to: tractor pulling hitches posted by sellufishman on September 19, 2006 at 16:44:32:
Well, there are two thoughts on this subject. Some tractors are light up front and some are heavy. Some will say that if you are heavy on the nose, that you should use a longer drawbar in order to help balance the weight over the rear tires. Some tractors are light on the nose, and a shorter drawbar will help. If you are pulling weighted classes, I would suggest setting up weight brackets like other guys and move the hitch as close to the rear axle as the rules will allow. Most put a bracket in the belly of the tractor, behind the rear axle and as far out in the front as the rules will allow. This way, in a weighted class, when you have moveable weight, you can put it where you need it.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|