Tractor Talk Discussion Board |
Re: Width of Tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Make sure you have enough on October 03, 2006 at 15:45:54 from (199.133.80.226):
In Reply to: Width of Tractor posted by oldfarmtractor on October 03, 2006 at 09:23:19:
For hauling an M Regardless if you pick an 84" deck between the fenders or a deck over trailer you will need to get 5200# or 6000# axles with brakes. A well made 18' or 20' trailer with mounted ramps will likely weigh 2400# to 2800# empty. This puts you in the range of 9000# to 10000# just for the tractor and trailer depending on options like weights (front or rear) and ballast in the tires. Getting equipped to haul an M ups the ante on the price of the trailer and the capacity of the truck required to pull it. If you stick with H's you can get by with a well built 78" trailer with brakes behind a well equipped 1/2 ton truck. Search you budget and put safety first. H's can look just as nice as an M and require a lot less fuel to haul and run if you are using them for recreational (therapy) purposes. Be Happy, but Be Safe First.
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|