|
Tractor Talk Discussion Board |
Tractor Parts?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Animal on October 11, 2006 at 17:52:56 from (172.161.169.109):
Like most of you fellas it was a cold blustery rainy day here in the show me state. I decided to try to finish up on a 8N Ford project I have been doing this summer, long story short I have spent the entire day getting a Chinese radiator shroud to mate up with an Indonisia radiator correctly so the fan would not smack it, and so it looked and fit better than a saddle on a sow! When I got that accomplished I proceeded to install an arm chair seat made in Japan on the tractor and I still do not have it finished to my liking yet! I paid darn good money for this junk. I sure wish we could get something made in the good old U.S.A. beside car payments and credit card bills.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
