|
Tractor Talk Discussion Board |
How to clean out cylinders
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on October 14, 2006 at 11:26:01 from (4.244.57.43):
Got one in that the cylinders, 2,3,and 4 seem to have a lot of rust/dirt in them. It tries to start but because of the dirt and rust fouls out the 3 plugs before it can start up. Short of pulling the head how can a guy get this stuff out of the cylinders?? By the way this is an an Allis D-17. I've filled the cylinders with oil and turn it over with out the plugs in, also did that with gas, then carb cleaner and PB. So far nothing is working to clean them out enough to get it to fire up. Any body got some other ideas. If I could turn it over by hand I'd just get each cylinder to the point the exhaust valve was open and pout oil in the exhaust manifold but I can't do that at this time.
Thanks for any ideas be them good bad or just plain crazy.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
