Tractor Talk Discussion Board |
Re: Hated to sell
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom in TN on October 15, 2006 at 16:23:20 from (4.152.96.235):
In Reply to: Hated to sell posted by KEH on October 15, 2006 at 15:19:09:
KEH, This might be an entirely situation, but my horses lifted a couple of steel gates off their hinges and went off for some fun on their own. I finally realized that when I put the hinge bolts into the fence post, I was supposed to put the bottom one in so that it pointed up and the top one in so that it pointed down. That holds the gate on so it can't be lifted off. I went around and changed all of the top hinge bolts on the all of the gates that I had installed, and haven't had any problems like that since. Sorry you had to sell your bull. Mine stays home, but I constantly fight my neighbor's bull to keep him over on his side of the fence. Tom in TN
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|