Tractor Talk Discussion Board |
Re: What would you do?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by coflyboy on October 25, 2006 at 11:56:48 from (67.42.186.227):
In Reply to: What would you do? posted by old on October 25, 2006 at 11:06:35:
If I was pretty sure about who the kids were that did it I think I would let their parents know. They might appreciate knowing. I think the post about plexiglas is a good one. If you put glass back in they'll just break them out again I was dragging out logs way back in the mountains with a 9N. This was off the road up and down valleys. Someone stole the steering wheel off the tractor. Long story short I drove it out pushing the steering rods with my feet. Lucky I didn't get killed.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|