Tractor Talk Discussion Board |
Re: Hydraulics Questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Old Pokey on November 11, 2006 at 08:03:38 from (216.99.219.239):
In Reply to: Re: Hydraulics Questions posted by Allan In NE on November 11, 2006 at 07:30:59:
The gpm part is what your pump puts out, not the valves "rating". If your pump puts out 25 gpm, the only problem would be getting that much through the holes if they're too small. This will just activate your main prv and bypass the oil. If those valves dont have a screw and lock nut behind the cover, you can still usually shim them to a higher pressure with no problems. Pretty much all these bypass valves have a spring in them. This spring can be shimmed to increase the pressure much the same way as turning the screw on an adjustable one. The only thing is, if you really wanted to know what pressure you increased it to, you'd have to plumb in a guage. I'm still a little vague on your "set-up" for the single action. Are you plannning on bypassing the oil in the "non-working" action? That would increase the heat build up considerably. If you want to simply send the oil back from the valve as you lower the loader, just run a short section of hose from the non-work port to the "out" side of the final valve body. There are other ways to plumb this machine if you want to use the tilt while lowering the loader. Also, I should say that I may have missed an earlier post or something, so we are talking about an open center system, right?
Replies:
Home
| Forums
Today's Featured Article -
Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|