Tractor Talk Discussion Board |
Re: The Ugly Part
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by R. John Johnson on November 16, 2006 at 11:12:47 from (205.200.43.42):
In Reply to: The Ugly Part posted by Allan In NE on November 16, 2006 at 09:34:27:
Allan Beauty is in the eye of the beholder. You'll be quite happy with her looks on those bitter cold days and the four legged critters with be more than overjoyed to see it bringing them food. Sounds like some sort of valve to control coolant flow is needed on that heater. Lots of options. Looks like you got the hydraulics plumbed up. I know its too late now, but if you replaced the two single acting valves with one double spool mono block, there are some valves out there that have a mechanical connection that allows the use of one control lever to control both spools. It ends up just like the joystick in previous posts, but without the cables in between. John
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|