Tractor Talk Discussion Board |
Re: diesel starting question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hurst in ky on November 18, 2006 at 08:29:36 from (66.129.5.5):
In Reply to: diesel starting question posted by Jeff Oliver on November 18, 2006 at 05:18:26:
Theres a lot that could cause it to not start w/out either. It could be injection pump timing, the head needing work, improperly adjusted valves, compression rings, or a bad starter or something in the electrical system not turning it over fast enough. Also, check the transmission and the fluid levels (use his manual), esp the rear end, the final drives, and the hydaulics (after running it around for a while of course). I have a 7000 (a 200 in different sheet metal and beefed up through the drive train with a 3spd powershift) and it is a great tractor. The 301 is a very good engine, very well built, it was making power that most other companies were using 400+ cubic inch engines for. Allis 301s do not start very well though, because their pistons use 2 compression rings which are shaped in a way that does not seal very well at cranking speeds, so it can take 10 seconds to start the tractor when it is in good shape at 50 degrees unless it has a "truseal" (I think that is right) or as it used to be known, the M&W overhaul kit (because M&W used to make them) which has different shaped rings that seal better at lower cranking speeds. Check it over and try to get a good price on the tractor. Also, try the unofficial-allis board, there are a lot of good allis guys over there. The compression rings would be the last things I would think, there is so much it could be instead that is easier to repair. Hurst
Replies:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|