Tractor Talk Discussion Board |
Re: Wisconsin engine part #'s
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on November 20, 2006 at 14:21:43 from (66.218.19.46):
In Reply to: Wisconsin engine part #'s posted by John S-B on November 20, 2006 at 13:57:01:
Should be an Autolite distributor Wisconsin 3 YF-10A-S1. Distributor cap is held on by two clips and is part # IG-1324D and rotor is IG-1657R. Wires come individually from Wisconsin, not as a set. #1 wire is 31" long, #2 wire is 42 3/4" long, #3 is 37 3/4" long and #4 is 45 3/4" long. Coil wire is 15" for open engine, and 27" for a power-unit. There is also an older model distributor that has a cap held on by two screws and is flat on top - wires come out the side. That is an Autolite IGW-4159-A and cap # IGB-224 & IGB1225D (two piece).
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|