Tractor Talk Discussion Board |
Re: John Deere 720
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by James2 on November 23, 2006 at 10:34:15 from (207.179.239.196):
In Reply to: Re: John Deere 720 posted by buickanddeere on November 22, 2006 at 16:13:36:
Everything appears to be OK. Checked all of the plates for flatness, The clutch snaps correctly and used JD parts. Probably the discs did not require replacing, they were worked OK but I just hated the burnt smell. This last set smells and the facing is also black but these will be used until failure. Also don't like that cheap clutch face dust cover. When the clutch gets hot, it has a tendency to come off. The clips are all in place and look OK. Bought new clips and may eventually install if the problem worsens. Really like the bolted-on cover on the big standards, a real robust design which "shouts" quality. No doubt a lot of our problem is not having "cut our teeth" Deeres. Trying to peer over your shoulder when in reverse and concurrently streching forward to control the hand clutch requires a lot of flexibility. At this age, flexibility is not one of our strong suits. Also having replaced the tricycle front end with a wide front end hasn't helped. Others have instructed me to use the right foot to "nudge" the clutch when in reverse. I have tried this and don't like the control aspect. I am also sure that we could eventually develop a shift-on-the-go technique, but you have heard the old story about teaching old dogs new tricks. Sometimes it is a lot easier to complain rather than change. Having "said" all of this, I still believe this is one great tractor. If we had bought one new in the late '50s, it would have been a prime candidate for a front hitch. I appreciate your interest and the positive/inquisitive rather than negative posts. From what I have read, you have been a big help to the YT JD owners. I have printed some of your posts and they go into the my "golden book" of JD information/repair.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|