Tractor Talk Discussion Board |
Re: One Wire Alternators.....
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jon Hagen on November 24, 2006 at 08:27:00 from (69.26.29.209):
In Reply to: Re: One Wire Alternators..... posted by Greg_Ky on November 24, 2006 at 07:00:12:
I use many 1 wire and 3 wire Delco alternators depending on the application, I build them myself from junkyard cores. The one wire conversion of a Delco alternator is simple and clean to wire IF the machine has a factory ammeter or voltmeter to indicate if the alternator is working. One rule is to not buy more 1 wire alternator than you need,the smaller the amp output,the lower the "kickin" rpm. A 37 amp 1 wire alternator will energize at less than 1/2 the rpm of a 72 amp 1 wire unit. Most machines that only need power for lights and ignition will do just fine with a 37 amp alternator. If the machine has only a "gen" light to indicate charge,them you are better off using the 3 wire delco alternator. The 3 wire Delco alternator will make the factory gen light work as intended,plus the wiring for the #1 exciter terminal is already present in the stock wiring harness,that with the fact that it excites at fast idle. I buy aftermarket 1 wire and 3 wire regulators by the box of 12 and build whatever fits the application. I have never found any indication that any parts are different between a 1 and 3 wire alternator except for the regulator. The instructions that came with a box of 1 wire regulators stated that if you have a situation where the "kick in" rpm is too high with your 1 wire alternator,you need only add a the #1 excite wire to your 1 wire alternator to make it operate as a stock 3 wire alternator. The only difference being that you still do not need the #2 sense wire,as the 1 wire regulator senses system voltage internally through the diode trio. There is a Factory stock Delco 1 wire kit designed for the 27 SI Delco alternators that fits the little 10-12SI units without modification. They consist of a special regulator and a regulator plug with a little red cap that can be inserted in 4 different positions for 4 different chargeing voltages,which seems to be of little value. I seldom use them ,as they are 5 times the cost of an aftermarket 1 wire regulator,and will slowly discharge your battery because they are constantly connected to the live battery stud. The aftermarket 1 wire regulators do not have any connection to battery power and will not drain your battery any more than a standard 3 wire alternator.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|