Tractor Talk Discussion Board |
Re: OT Cold air return
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rustyj14 on December 03, 2006 at 17:37:33 from (71.162.11.2):
In Reply to: OT Cold air return posted by Indiana George on December 03, 2006 at 16:34:24:
The furnace heats the air-the blower sends the heated air up thru the heat pipes,usually tin, square or round galvanised pipes, usually in the walls, maybe the floor. Various square or rectangular pipes, thin tin. Usually one outlet in each room. Then there might be a cold air return in each room, which sends the cooler air back down through a larger tin pipe, into the blower area of the furnace, from whence it is heated by the furnace, and blown back up thru the tin pipes mentioned before. now, if you don't have a cold air return, your furnace can't complete the heating cycle. And, it will waste gas, or fuel oil, propane, etc., by running more to accomplish the heating of the house. If you don't have a furnace blower, then the house is usually heated by a large floor vent, connected directly to the furnace, and the heat will then drift around the house, and eventually upstairs. This heating method was in use in the 1880's and early nineties. Most homes built since the 30's have forced air, steam heat, or some other method of heating, especially the upstairs. I think you should install some other type of heating, especially if you live in a cold climate. you'll save a bundle on gas, oil, propane, whatever you use. Talk to the local furnace installer. they can set you aright on how to do it right!
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|