Tractor Talk Discussion Board |
Re: Shop heat
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Michael Soldan on December 07, 2006 at 12:41:12 from (24.235.41.226):
In Reply to: Shop heat posted by Animal on December 07, 2006 at 10:46:28:
Many years ago when I built my shop at home my parents had their furnace replaced at the farm. The old unit was a huge wood and coal furnace. I decided that it would work in my shop so I brought it home, bolted it together and got pipes etc. I fired it up and after a while it was quite warm so I opened a window , then after a while I opened the enterance door and yet later opened one of the twp bay doors. That thing will heat you out. I have learned to damper and control it and I like it. If I light it around 7:30 I can work all day in my shirtsleeves by 8:30. If I have a project going I can put two or three big blocks of wood in and it will still be going in the morning. My shop at home is 24x30 double bay. I got heat!!
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|