Tractor Talk Discussion Board |
Re: What to set tire width at?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by The Dukester on December 17, 2006 at 14:15:41 from (4.229.129.127):
In Reply to: What to set tire width at? posted by Mark Johnson on December 17, 2006 at 08:00:38:
Well, I've got 2 trailers with about 84 inch width decks and one has side rails. I like to do a lot of plowing so I've set the wheels on my A, G and GW John Deeres so there is about 60 inches between the wheels and they are about 82 1/2 or 83 inches overall width at the tires with the axles of the G types at 84 inches width and the A at 86. There is a little axle sticking out but not much...even on the A, This width fits the trailers and works out good pulling 3-14" plows. The wheels on my MM UTU are a little closer together at about 57 inches because it has 15.5 tires on 15 inch rims so to load it on either of the trailers requires the closer spacing. About 3 inches of axle and washer and capscrew stick out beyond the tire width on this tractor. The H and M Farmalls have their wheels in the "dished out" position and the H's wheels are about 1" away from the housing and the M's about 1/2" away. The M is too wide for the trailer with siderails but we can load it on the other one by removing the left fender, loading the tractor, and then replacing the fender. You can upset any tractor with any wheel spacing if you don't know what you're doing and get careless. Like any other machine you operate it safely with knowledge and respect. Stupidity and carelessness get you killed, not wheel spacing.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|