|
Tractor Talk Discussion Board |
Re: Grinders revisited
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TP from Central PA on December 17, 2006 at 18:42:31 from (152.163.100.74):
In Reply to: Grinders revisited posted by IaGary on December 17, 2006 at 18:13:26:
I agree on the power part, but I don"t think they grind any fast, I know guys around here with Gehls and they need more tractor I did for my NH or Arts-Way................I had a 357 NH Mill, ran it with a warmed up M-TA and it did everything I wanted it to, and actually worked better with the M-TA than a 706D. My neighbors have a 125 Gehl and use the same size screeen I did and you couldn"t run that with a smaller tractor if you wanted to, unless you put in one ear of corn at a time.......100 hp 766 is the limit on the low end and you still can outshovel it if you wanted to from a corn crib. My grandfather has a 95 as well, and its a power sink.........takes 80 hp to run it. I"d never have a Gehl, it be a 357 NH or Arts-Way......I"ve been known to grind feed with what ever was at the farm where the mill was. We used our "49 JD A more than acouple times when everything else was tied up..........Slow, but got "er done. Out of all the mills I"ve seen and used, if you have a problem with grinding a batch of feed in the least amount of time, get yourself a old big Farmhand Mill(Big models with tandem axles under them) and put a real tractor on the shaft(1256 or something like it)..........
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
