Tractor Talk Discussion Board |
Re: OT - Jeeps
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fawteen on December 22, 2006 at 12:18:33 from (66.181.126.162):
In Reply to: OT - Jeeps posted by Bill from MA on December 22, 2006 at 10:34:39:
Disclaimer: What follows is just my opinion, and based largely on input from other folks (AKA "hearsay") but it's so consistent, I have to think it's at least somewhat accurate. YMMV... Jeeps are built with whatever parts happen to be handy. Is not at all unusual to have a mixture of fasteners, some metric, some SAE, holding on the same part. Pre-AMC Jeeps are okay, everybody that's owned the name since AMC has made a cash cow out of it and ridden on the name. You can buy more 4x4 for less money from virtually any other manufacturer.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|