|
Tractor Talk Discussion Board |
OK another electric fence post
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmer in the Dells (WI) on December 31, 2006 at 06:35:51 from (66.187.42.96):
New Years Eve and raining so I don't have to go water my ground rods. :) Anyway, I was thinking about the post that someone tests the wire with a piece of grass getting shorter until they feel the charge. I am guessing that was with the old style weed cutter chargers. Since the pulse chargers are out I test the line with a transistor radio. On AM off station you can hear the pop and that's good enough for me. I did see a post that tested the amount of charge though and I have a dead end line. How is that done on a pulse charged line? Is the charge long enough for a meter to read or are they close enough together that the meter does not reset? Can I assume a non contact loop type meter is used?
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
