Re: 12v DC to 115v AC for boiler pump

Posted by jdemaris on December 31, 2006 at 12:17:38 from (69.67.229.62):

In Reply to: 12v DC to 115v AC for boiler pump posted by JoeBob/IN on December 31, 2006 at 11:32:17:

There are many ways to do it. I run the electric hot-air blower on my wood-furnace with solar - and it draws a lot more current than a water-circulator does. When it's gets good and cold outside, my blower draws 3 amps at 120V for 15-20 hours a day.
You need to figure what the most current use in one day is for your setup. You then have to figure how much electricity - producing sun is available on an average winter day. In my area - four hours is used as an average - but we actually get less. If you get four hours - you then have to have enough solar-panel wattage to produce the power you need in that four hours - actually about 20% more. That 20% takes into account inverter loss, battery storage loss, etc. You also have to size your battery bank to be capable of running with no sun for X amount of time. Since you have grid backup - seems 20 hours of battery storage is a good goal. If, for example, your circulator draws 1 amp at 120 VAC, and runs 6 hours a day - it then uses 720 watt-hours. Add 20% to that for loss, i.e. you have 864 watt-hours. You need approx. a minimum of 200 watts in solar panels. A good buy on solar panels comes to around 4.50 per watt - so two 100 watt panels will cost you around $900 if you buy right. And, the Federal government will give you a tax credit for part of it. For batteries - to have 844 watt-hours of storage - take a battery and mulitply its AH rating times its voltage. For example, a Trojan golf-cart deep-cycle battery is 6 volts and 225 AH - i.e. 1350 watt-hours. You need 12 volts for an inverter, therefore you hook two of the Trojan 6 volt batteries in series - and get 12 volts but the watt-hour storage stays the same. Series connections do not change watt-hours - only parallel connections do.
These are just examples. I don't know how much reserve you want, how much sun you get, etc.
In answer to an automatic system - there are inverters made just for that purpose. When the batteries reach a state of low-charge, the inverter automatically switches over to grid-power - or an automatic-starting fuel-driven generator if you want.
Cheapest automatic inverter I know of on the market is a Trace/Xantrex DR series. It is cheaper than most because it's a modified-wave inverter - and today - any house hooked on solar to feed back to the grid (grid-tie) requires a full-wave inverter - and they are much more expensive. Just priced an inverter for my house if I want to go to grid-tie and it's list price is $5500. You can buy a Trace DR 2000 watt inverter - with a 12 volt input and 120 VAC - with built in battery charger, automatic changeover to grid, etc. - for around $400-$600 but you have to shop around. If you don't want automatic changeover, you can buy all kinds of $100 inverters that will do the job of voltage-conversion - but the changeover will be up to you.

Replies:

• Re: 12v DC to 115v AC for boiler pump RP2 13:11:11 12/31/06 (2)
  • Re: 12v DC to 115v AC for boiler pump jdemaris 14:48:15 12/31/06 (1)
    • Re: 12v DC to 115v AC for boiler pump buickanddeere 19:53:15 12/31/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]