Tractor Talk Discussion Board |
Re: Chevy K2500
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on January 02, 2007 at 19:51:14 from (69.178.229.154):
In Reply to: Chevy K2500 posted by Tweeter on January 02, 2007 at 16:01:43:
Just because the electronic heater contol "head" appears to be functioning does NOT mean the servomotor attached to the heat control (blend) door is following what the control "head" tells it to do. There is NO feed back from the servomotor to the control head. The control "head" simply issues a positioning command and ASSUMES the motor has obeyed. The bar graph on the control "head" display will move, even though the servomotor DOESN'T move. You may have a control "head" problem, where the "head" shows the bargraph moving and is defective, and not sending the signal to the servomotor. You may have a wiring problem between the contol "head" and the servomotor. You may have a defective servomotor, OR a mechanical problem, where the servo is moving, and the "blend door" is not. Also, the blend door is plastic, and has a rubber flange around it. Sometimes, the rubber lets go of the plastic door, so the door no longer seals, allowing cold air to bypass the heater core. LOTS of stuff to check, all located in a MISERABLE place to work!
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|