Tractor Talk Discussion Board |
Re: 8n funk conversion radiator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hal/WA on January 06, 2007 at 21:13:00 from (66.45.175.118):
In Reply to: 8n funk conversion radiator posted by Billy White on January 06, 2007 at 19:55:04:
I have never had anything with a Funk conversion, but I have messed with flatheads and have had radiators rebuilt. Flatheads need quite large radiators, since the design tends to put a bunch of heat into the coolant. If the conversion is a V8, I would wonder if the radiator used came from a Ford car. If so, it might be cheaper to just buy a new radiator for the car than working on the old one. I can't think of another radiator that uses 4 nipples for radiator hoses than one for a flathead V8. Hemmings or the internet might produce a good deal on a repro radiator. The cost of "rebuilding" a radiator depends on what the radiator shop has to do to it, and what parts can be reused. Just having a radiator rodded out, cleaned and resealed is a lot cheaper than recoring one. And if the tanks are bad, it might be very expensive to build them, especially if they have to look factory. Good luck! The Funk conversions I have seen were neat, powerful tractors.
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|