Tractor Talk Discussion Board |
Re: oliver repower for work and pulling
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jeff Oliver on January 07, 2007 at 19:12:16 from (74.38.169.211):
In Reply to: oliver repower for work and pulling posted by wegman in Mn on January 07, 2007 at 16:43:52:
If you have enough time and welding rods you can put anything in anything. Don't know about a CAT V8 in a 770 for field work though. Seems kinda over kill plus I am not sure the tranny or rear end would hold up to almost triple the horsepower of what it is supposed to handle. However if you do the conversion post pics as it would be neat. Don't think any pull I know of would let you pull that setup in an (out of field) pull though. Exibition maybe:)
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|