Tractor Talk Discussion Board |
Re: What is the most DANGROUS
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by PhilcaseinWPa on January 08, 2007 at 10:00:37 from (146.186.55.48):
In Reply to: What is the most DANGROUS posted by raleigh on January 08, 2007 at 06:43:32:
Most dangerous thing i can think of is me at one time. I'm older and hopefully wiser now but I had some very close calls. Scariest one involved both my kids. Son was about 6 or 7 and rode with me to the field. Sit on my lap and steer. He was finally tall enough to reach the pedals if he stood at the very front of the seat. We came back from the field and pulled into the drive, not fast. I told him to push in the clutch and break and he did. Just then my daughter (2 years younger) came running up to the tractor right infront of the rear wheel. Well the son must of figured the tractor was stopped or probably just didn't know any better and took his foot off the clutch. The tractor jumped forward and the rear wheel knocked my daughter backwards right in front of the wheel. I don't know how i did it so fast but I slammed the break and stalled the tractor before the wheel ran over her. Probably the worst and the luckiet moment of my life. Kids didn't ride on the tractors much after that and I think I got a little smarter and grayer. Anyway both kids are successful adults now (29 / 27) and I didn't try to kill them too many more times. They were luckier than I was smart. Still gives me a sinking feeling in the pit of my stomach. Can't tell me there are not guardian angels out there. Phil ps maybe someday I'll tell about the kids and the runaway truck another dumb dad move.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|