Tractor Talk Discussion Board |
Re: 6-volt Generator Repair
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on January 15, 2007 at 19:48:48 from (66.244.90.5):
In Reply to: 6-volt Generator Repair posted by AWB on January 15, 2007 at 18:10:05:
If it reallyyyyyyy? needs BOTH a new armature plus field coils, it may be wiser to go ahead n buy a whole new rebuilt unit n be done with it. Often its only a set of brushes n maybe a bushing n have the commutator turned is about all they usually require. However if the bushings were so shot the armature was dragging it may be shot and they arent cheap. If the armature isnt shorted to ground and passes the smell test it might be fine n all you need is brushes, maybe a bushing??? John T
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|