|
Tractor Talk Discussion Board |
Sometimes you wonder why people do what they do!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by wagsw900 on January 16, 2007 at 18:01:31 from (68.113.236.201):
Just started working on a new used semi we purchased. It's a 1975 Kenworth W900A. We need another truck for a backup to the Diamond Reo. Pulled it in the shop, and started to look over it. What we found was a can of worms. It was a woods truck and it had a huge wet kit that leaked and was a back woods mounting system....welded right to the frame. Bolts that had no thread so they just welded them to hold. Old airlines that were junk still mounted everwhere. A scab job for the back lights using speaker wire. The shift handle was broke instead of replacing the used a roll of duck tape to fasten in down to the stick. What they call chicken lights all over the cab. Electrical connections hot glued together. No wires or hoses wrapped up nice either all laying and rubbing on something. If something broke they just left the old and scabed the junk in. It just makes you wonder if some people even care about there equipment. I know its old but still. A week in the shop and she be be road worthy again. I'll post some pics at a later date. Any of you have has experiances like this??? Erik
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
