Tractor Talk Discussion Board |
Re: (OT) Forklift Lifting Ques.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pitch on January 27, 2007 at 01:52:57 from (66.66.96.172):
In Reply to: (OT) Forklift Lifting Ques. posted by doogdoog on January 27, 2007 at 00:25:49:
Your talking a regular forklift right? I haven't been around forklifts for 15 years but you can do it. Lift it just enough to change a tire or put on chains. Raise your forks enough to get them out of your way and tilt back . jam blocking under the bottom of each lower mast section or under the side you want up and tilt forward . Should lift 4 or 5 inches.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|