Re: John Deere B

Posted by B-maniac on January 30, 2007 at 14:33:28 from (207.241.132.238):

In Reply to: John Deere B posted by MT on January 30, 2007 at 11:11:13:

What you may be seeing is the "factory" weld where the frame makes a 90 degree "bend' to form the flange that bolts to the trans. This flange was a seperate piece from the frame stamping and then welded to make the 90 degree bend. In other words , the frame including the bolt flange was not stamped from one piece of steel. There is a verticle weld there. Welds anywhere else were probably caused by stress cracks caused by either running too large a front mtd. cultivator or trying to "plow" with a 2 row cult.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]