Tractor Talk Discussion Board |
Re: Pole Barn Concrete
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Clint Youse on January 31, 2007 at 15:46:08 from (64.111.61.87):
In Reply to: Pole Barn Concrete posted by Tpohl on January 31, 2007 at 05:57:35:
Have a 40x 100 all concrete it is a waste but i did not build it park stuff on half of it use other half as shop the half i park old junk always got a oil leak or some thing else to clean up if it was rock would not have to worry about it. Also Got a 54x60 at my dad's place concreted the front 24ft works great can work on any thing up gront use the back for parking when we poured it just used the bottom board for a form then run a 2x6 along the back gud down about 8inches below the bottom of the concrete all around the outside and reinforced it real good with plenty of rebar. then in the back we put base rock down to level it all up and the base rock will pack in pretty tight Clint
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor: Part 2 - by Anthony West. In February 1953 production of the ETC T.V.O engine started, ready for the March 1953 press announcements. The new TVO engine had a number of improvements which resulted in a 10 per cent more power (43bhp as against 38 bhp on the earlier engine) and 10 per cent more fuel economy. Some of the improvements are listed below: Redesigned combustion chamber, improved spark plugs and positioning, plug size 14mm(earlier size 18mm).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|